Canon DR-1210C USBスキャナがあります。
挿入されると、カーネルはそれを認識します。
[5365651.911506] usb 2-2.1: USB disconnect, address 3
[5365661.952066] usb 2-2: USB disconnect, address 2
[5365683.268060] usb 2-2: new full speed USB device using uhci_hcd and address 4
[5365683.441019] usb 2-2: New USB device found, idVendor=1083, idProduct=160f
[5365683.441027] usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[5365683.441033] usb 2-2: Product: CANON DR-1210C
[5365683.441037] usb 2-2: Manufacturer: CANON
[5365683.441248] usb 2-2: configuration #1 chosen from 1 choice
sane-find-scanner
あなたはそれを見ることができます:
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
found USB scanner (vendor=0x1083 [CANON ], product=0x160f [CANON DR-1210C ], chip=GL845) at libusb:002:004
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
found USB scanner (vendor=0x1083 [CANON ], product=0x160f [CANON DR-1210C ], chip=GL845) at libusb:002:004
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
ところでscanimage -L
スキャナーがないと出てきますね。
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
それでは、私が何を見逃しているのでしょうか? HOWTOをフォローしてみましたが、問題解決の提案による洞察を得られませんでした。
答え1
これは、実行中のユーザーがデバイスにアクセスできない場合にscanimage
一般的です。以下を使用して、デバイスが属するグループを確認できます。
ls -la /dev/bus/usb/002/004
(この002/004
部分は出力から取得されます)ユーザーがデバイスを所有しているグループのメンバーであることをsane-find-scanner
確認してください。変更後はデーモンを再起動する必要がsaned
あります。saned